Mousetrap racer report essay

Then I cut off 2 sides of the vehicle with a width of 1. Evans, Evans, and Nixon it seemed easy.

Mousetrap Racer Report Essay Sample

I hot glued the last resort of the rope to the middle of the axle and tied the front end to the Mousetrap racer report essay so that when the lever pulls my car will be able to move forward the rope length was about 12 inches.

My simple machine transferred kinetic energy and made work easier. I made two holes on each sides and glued the side to the body and made sure that they keep strong. Then I was completely done except for one thing and that is the small metal bar on my mousetrap handle acting as lever, and one more thing I added after the lever was the ropes.

This is how it was done, it was a great experience. I cut of a wooden piece with the width of 2 inches and length of 9 inches. The materials used were: Get Full Essay Get access to this section to get all help you need with your essay and educational issues.

More essays like this: The bar with the handle was about 4 inches.

The Vehicle travelled exactly 12 feet as expected. So with the use of two simple machines my vehicle travelled the required distance.

I was done with the mousetrap holder, sides and axles, moreover I was done with the body of my vehicle. Like everyone my vehicle was also made of wooden pieces and mousetraps.

The bar was a 2nd class lever, because the fulcrum was the top of the handle where the bar was glued and the load was the force acting to pull it down, gravity, and the effort was the mousetrap trying to hunch back to its regular placing, causing the rope to be pulled and the car to go in front.

Firstly I started off with the piece that was provided. My ideas of simple machines were put to a test when I did this project. Then I cut of the half of a big axle and made it in half and cut the half to another half. Now that I was done with all that I glued the mousetrap to the body, then I glued discs of 4.

It took me exactly 10 days to make my vehicle completely and with the help of Mr. My wheel and axle were 2nd class too because the effort and load gravity were acting on the same downward direction.Mousetrap Vehicle Report My Mousetrap vehicle turned out to be pretty good and in great working condition.

My ideas of simple machines were put to a test when I did this project. Physical Science Mr. Shepherd Mousetrap Car Project Introduction: You will build an originally designed vehicle powered solely by the Mousetrap Car Physics Analysis (Report) Design Instructions: 1.

The vehicle must be powered by a single “Victor” brand mousetrap or equivalent. mousetrap • A mousetrap is a simple fulcrum A mousetrap is a simple machine because it uses mechanical advantage to lti l f applied force multiply force • The mousetrap acts as a third-class lever with the resultant force (load) class lever, with.

Mousetrap Racer Report Essay Sample.

My Mousetrap vehicle turned out to be pretty good and in great working condition. My ideas of simple machines were put to.

Overview: Using your mousetrap car, conduct an experiment to see how a design change affects the distance that your car travels. Follow the steps below. Your grade will be based on your lab procedures and your final lab report.

MOUSETRAP RACECAR PROJECT Due Date: September 24 th/25 th, INTRODUCTION The mousetrap car shows how energy can be transmitted from one location to another to accomplish some form of work.

Download
Mousetrap racer report essay
Rated 5/5 based on 77 review